Clean nebulizer as indicated above.
Cleaning nebulizer parts with vinegar.
Rinse the area with water.
Apply the paste directly to the stained area.
A nebulizer has five basic parts.
After use throw out the vinegar and water solution.
Nebulizer parts except mask tubing and compressor in one part distilled white vinegar three parts hot water for one hour do not reuse cleaning solution.
Clean the mask mouthpiece and t shaped connector as you would daily.
Rinse shake off excess water and allow to air dry on a clean towel.
Soak for 30 minutes in a solution of one part distilled white vinegar and two parts distilled water.
You may be instructed to soak all nebulizer parts except mask tubing and compressor in one part distilled white vinegar three parts hot water for one hour do not reuse cleaning solution.
Just let them sit for an hour then put them on a towel to air dry.
Cleaning your nebulizer is important to prevent the spread of germs and keep you from getting sick.
Rinse the nebulizer parts again under warm running water for one minute or rinse with distilled or sterile water if possible.
Rinse shake off excess water and place parts on a clean towel to air dry.
At the end of each day the nebulizer cup mask or mouthpiece should be washed in warm soapy water using a mild detergent.
Another simple way to sterilize is to soak the nebulizer parts except for the tubing mask and compressor in a solution composed of one part distilled white vinegar and three parts hot water.
Allow the paste to sit for several minutes before wiping it up with a clean towel.
Reassemble the pieces and tubing and turn on the compressor briefly to dry.
Shake off excess water and let it air dry.
Soak the nebulizer parts except the tubing and mask for 60 minutes then rinse thoroughly.
For tough carpet or fabric stains mix equal parts vinegar table salt and borax in a large bowl until a paste forms.
Do not re use it.
Dry them with a clean towel.
For low level disinfection every other treatment day.
Do not put the nebulizer tubing mask or compressor through a dishwasher.
Rinse the nebulizer parts under warm running water for 1 minute.
In a clean bowl prepare a cleaning solution consisting of one part white vinegar and two parts sterile water.
Throw the solution out afterwards.
Many people with chronic lung diseases such as copd or asthma use a nebulizer to take their medication in the form of a mist that is inhaled into the lungs.
Soak the aforementioned parts in the solution for 30 minutes.
Shake off excess water.
To make your own cleaning solution mix one part white vinegar to three parts water.
Reassemble the pieces and tubing and turn on the compressor briefly for drying.
After each treatment rinse the nebulizer cup with warm water.
X research source for example you might combine 1 2 cup of white vinegar with 1 1 2 cups of water.
