But after i relase control box i found i have to take out condensate trap before moving blower.
Clean carrier furnace condensate trap.
Shoud i just disconnect those pipes on trap then remove trap.
When an air conditioning system is mounted above a furnace you might see rust forming on the furnace.
The drainage system needs to be checked for blockage and or leakage.
This condensate typically runs through the ez trap and is then drained.
I am going to take out carrier furnace blower it doesnt run.
3 pipes connected to this trap at top 1 at the bottom.
This one covers how to clean the condensate drain of the 90 gas furnace.
Thanks for the correct way to take it out.
You can prevent slime and eliminate drain tube clogs in two easy steps.
The condensate trap is absolutely mandatory for a high efficiency gas furnace.
The condensate drain and trap need to be cleaned and the water replaced in.
As the system runs condensate a fancy word for water is created.
Turn off the power to your hvac system at the breaker and the thermostat.
How to clean out your condensate drain.
Always remember water and electricity do not mix.
This includes the hoses internal to the furnace.
Over time it can become trapped in your condensate drain line causing blockage.
Over time sediment builds along the inside of the condensation line and reduces the furnace s ability to rid itself of excess water that has been created as a result of the function of the heating elements inside the furnace.
Find the condensate pan.
Call your professional at oasis when in doubt.
In the image below you can see what the ez trap looks like.
As a preventative measure many hvac technicians will inspect and clear debris from the ac condensate drain during your annual maintenance tune up.
Since the drain taps into the exhaust system leaving it open to the air would allow for a potential exhaust flue gas leak in the living space which is a big no no.
When you see water puddling around the furnace with the a c running you have a clogged condensate drain tube.
Condensating furnaces are fantastic until the condensation lines start to get clogged.
An ez trap is a device that provides overflow protection for your heat pump and furnace cooling system.
If this drain is plugged the unit may not close the pressure switch.
